Furnace and heating repair in Upperville.
Heating repair in Upperville starts with a $99 diagnostic visit. Homes in 20184 mostly heat with a heat pump or propane, and we repair both.
- Prices in writing, first
- Furnaces, heat pumps and boilers
- Dedicated HVAC team
Get your heating repair priced
Upperville winters: 115 freezing nights under the ridge, deep snow and glaze ice.
Upperville’s winter figures come from the Purcellville co-op station, within 50 feet of the village’s height. NOAA’s 1991 to 2020 normals there average a January low of 24.5 degrees, around 115 nights a year at or below freezing, about five at 10 or colder and close to a dozen days when the high never gets past 32. Fauquier County’s building rules size heat for 17 degrees outside, so on the few nights colder than that, a heat pump leaning on its backup strips is doing its job.
The Census sample for 20184 is small, but it counted no owner home on natural gas: about two in three heat with electricity, the rest with propane. That’s a heat pump, sometimes backed by a propane furnace, or a propane furnace paired with central air. A propane furnace typically uses the same igniter, flame sensor and control board as a gas one, just set up for LP, so the repairs are familiar: a flame sensor cleaned for $95 to $180, an igniter for $240 to $410, a control board for $550 to $1,180.
Snow is the big test. The Weather Service put the January 2016 blizzard at 24 to 36 inches across northern Fauquier, and observers at Bluemont and Middleburg, about eight miles north and east, measured 36 and 34. A high-efficiency propane furnace breathes through two plastic pipes low on a side wall, and a drift over them trips the pressure switch and shuts the burner down. Brush both clear, then switch the furnace off and on. Still no flame, and it’s a call.
Ice is the other: a February 2016 storm glazed northern Fauquier two to three tenths of an inch deep, enough to seal a heat pump’s coil and bow the limbs over a village shaded end to end by masses of trees. Defrost melts frost, not freezing rain. If the outdoor unit is encased, set the thermostat to emergency heat and phone us. When wires come down, the heat goes with the lights.
What furnace repair costs in Upperville.
The same price book as the rest of our site. The diagnostic visit is $99, and the tech prices the repair before starting it.
- Flame sensor cleaned$95 to $180
- Igniter or flame sensor replaced$240 to $410
- Blower wheel pulled and cleaned$300 to $440
- Thermostat replaced$300 to $640
- Control board$550 to $1,180
- Blower motor$670 to $2,400
- Repair diagnostic visit$99
Often same-day, and we will tell you honestly when we can get there.
With Comfort+ membership, $20 a month or $199 a year, the diagnostic visit is included, any service is 15% off, and a heating maintenance visit comes every fall.
What a failing furnace in Upperville usually does.
The propane furnace quits after every snowfall
If drifts bury the side-wall pipes every storm, they may need raising above the drift line, and the tech can price that on the spot.
It smells the first time it runs
Dust burning off the heat exchanger smells for the first few minutes of the season, then stops. A gas smell is different: leave the house and call your gas company from outside.
It runs a few minutes, stops, starts again
Short cycling is usually a clogged filter, a thermostat in a bad spot, or a furnace too big for the house. The filter is the one to check yourself first.
What the county says about your heat in Upperville.
Fauquier County
Fauquier County Fire Rescue takes requests for help getting smoke and carbon monoxide alarms through a form on its Public Education page. Source.
Loudoun County
Loudoun County Fire and Rescue says to have heating equipment and chimneys cleaned and inspected every year by a qualified professional, and to keep anything that can burn at least three feet from all heating equipment. Source.
In its fall clock-change reminder, Loudoun County’s fire and rescue system tells residents to check their carbon monoxide alarms, and recommends one outside each sleeping area and on each level of the home, tested monthly. Source.
How to pick the best furnace repair company in Upperville.
Questions worth asking anybody who comes out, us included.
Can they test the heat pump and the propane side on one visit?
Around 20184 some houses have both as a dual fuel system. Ask whether the tech checks the heat pump’s defrost and strips and the furnace’s flame and venting, not just whichever was running.
Will they price the part before they fix it?
Flame sensors, igniters and control boards all have a going rate. A tech who can’t tell you the number before starting is asking you to find out afterwards.
Do they look at the venting, not just the flame?
Getting the burners lit is half a heating call. Ask whether they check the flue and test for carbon monoxide while the panel’s open.
Do they know when a repair isn’t worth it?
A big repair on a furnace past 15 or 20 years deserves a replacement price next to it. A good tech puts both numbers in front of you and lets you choose.
What our customers say.
Steven came by and diagnose the issue with my heat very fast. He was extremely professional and kind. I will be definitely be recommending him to other friends and family ASAP
5.0 stars across 884 Google reviews. Read them on our reviews page.
Heating repair questions from Upperville.
How cold does Upperville get, and can a heat pump keep up?
Mount Weather, on the ridge five miles north, logs about 7 percent more heating degree days than Purcellville’s roughly 4,940. A properly sized heat pump with its strips handles that; one running its strips on a 40-degree day has a fault worth finding.
Does heating repair cost more in a 200-year-old house?
No. The $99 diagnostic visit is the same, and the parts come from the same book: a blower motor $670 to $2,400, a blower wheel pulled and cleaned $300 to $440. Thick walls and a long crawl change the work around the part, not its price.
How much does furnace repair cost in Upperville?
The diagnostic visit is $99. A flame sensor cleaned is $95 to $180; an igniter or flame sensor replaced, $240 to $410; a control board, $550 to $1,180; a blower motor, $670 to $2,400.
Should I repair it or replace it?
Fix the small parts on almost anything. Before a big repair on an old furnace, look at the replacement number: a furnace alone, keeping the air conditioner you have, runs $4,285 to $14,040 installed, and the HVAC estimator gives your number in about a minute.
Furnace repair in the towns next door.
More from SwiftPro in Upperville
Tell us what your heat is doing.
Call, or book online and pick a window. The tech prices the repair from the book before starting, and if the furnace is at the end of its life you’ll hear that first.
SwiftPro Heating, Cooling & Plumbing is a licensed, BBB Accredited (A rating), independently owned heating, cooling and plumbing company in Chantilly, serving Upperville and the rest of Northern Virginia. Virginia contractor license #2705192276. 5.0 stars across 884 Google reviews. SwiftPro maintains a dedicated HVAC team and a dedicated plumbing team.
SwiftPro Heating, Cooling & Plumbing, 4230 Lafayette Center Dr, Suite N, Chantilly, VA 20151, (703) 997-9757. Book online, read our reviews, or see every town we serve.